Creality Ender-5 3D Printer for sale.
Brand new upgrades:
New 2 sided spring steel build plate, one side textured PEI and one side smooth PEI w/ a new high temperature magnet.
New SKR E3 mini V3.
0 motherboard.
New TFT35 V3.
0 dual mode LCD/Touchscreen.
New direct drive adapter.
New 8 GB micro SD card.
New bearings and new linear rods for the Z axis.
New Creality heated bed.
I've added few NeoPixels on the inner front frame for event lighting and print area illumination.
New WiFi adapter installed.
All new frame.
Features:
BLTouch.
New brass leadscrew nut installed with 2 new spares.
2 new anti-backlash leadscrew nuts included as well.
A selection of new high quality nozzles: .
4mm hardened steel x2, 1 each of .
2mm, .
3mm, .
5mm and .
6mm brass nozzles and 20 new .
4mm brass nozzles.
5x .
4mm nozzle clearing needles.
The hotend has had a new heatblock, thermistor, new 40 watt heater cartridge and new .
4mm brass nozzle installed.
New thermal insulation has been added to the heated bed.
A Creality glass build plate (slightly used).
Dual mode LCD/Touchscreen
Neopixel LED lights illuminate print area with event lighting (different colors for heating/cooling/printing/etc.
)
Resume print after power loss, in the event of a power outage during a print, the print can be resumed when power returns.
Direct drive extrusion with a dual gear BMG extruder and lightweight pancake stepper motor.
I'll include the original carriage plate for switching back to a bowden extrusion setup if that's what you prefer.
The printer has a 235x225x320 print area.
Prints PLA, PETG, ABS, ASA and TPU
The original frame was damaged so the entire frame has been replaced with new aluminum extrusions,
all drive mechanisms have been brought up to new standards and properly greased/oiled,
belts checked and tensioned and all the v-slot rollers have been checked and properly adjusted.
Printer has Marlin 2.
1.
x bugfix firmware, compiled for the brand new SKR E3 mini V3.
0 mainboard,
checked and rechecked to ensure it runs flawlessly.
TFT has been updated to the most recent firmware available from BTT.
I'll include all the source files for all firmware.
Basic calibrations - homing offsets, z_probe offset, e-steps, PID tuning for hotend, etc.
have been done.
It's a very nice printer, rebuilt as new, with many upgrades and extras, asking $350.
*I actually rebuilt this printer last January but due to health issues I never got around to posting it for sale.
This is a great entry level printer, especially with all the upgrades I installed.
It would make a great Christmas gift.
Whatsapp
